0

Your Cart is Empty

BlackTip JetSports Traction Mats For Sea-Doo GS Family

130BT106

All mat kits come standard with BlackTip Jetsports exclusive PSA (pressure sensitive adhesive) to make installation easy - without the big mess of having to glue them down. Simply peel the backing off - press the mats into place and they are ready to go. This is an easy afternoon job and makes a world of difference on how your ski looks.

Color samples may be sent to you upon request or viewed by clicking this link Color Samples BlackTip Jetsports Traction Mats are in stock and usually available same day in Cut Groove Black. *Please note, we only accept returns on black cut-groove mats. All other mats are not stocked and considered custom.Each kit is specific to the Year, Make and Model of your craft, please verify this information before purchasing.



If you need assistance ordering or just have a few questions, please contact a member of our team by email Sales@WatercraftSuperstore.net or by toll free 866-957-9277 To complete your custom BlackTip Jetsports look, please visit our BlackTip Jetsports Custom Seat Covers **Red Traction Mats may fade if left uncovered while not in use.**

1997 GS
1997 GS
1998 GS
1998 GS
1999 GS
1999 GS
2000 GS
2000 GS
2001 GS
2001 GS
1997 GSI
1997 GSI
1996 GSX
1996 GSX
1997 GSX
1997 GSX
1998 GSX Limited
1999 GSX Limited
1999 GSX Limited
1998 GSX Limited (White Motor)
1999 GSX RFI
1999 GSX RFI
2000 GSX RFI
2000 GSX RFI
Removal of original riveted mats :Drill the heads off of the rivets holding down the original mats while pushing the remaining rivet into the hull. Fill the holes left by the rivet with 5min. epoxy, this can be purchased locally at any auto parts store. Make sure to scrape the epoxy flat in the foot wells so the new mats will lay flush. Clean the area that the new mats will be attached to with acetone solvent for proper adhesion.

Removal of original glue down mats:By hand, peel off any old mat material that you are able to and then you use a putty knife to help remove all material from the difficult areas. Areas that are difficult may require spraying WD-40 brand lubricant in between the mat and hull to help loosen the old adhesive. Take your time on the prep work; this is important to achieve professional results.

Now that your surface is clean and ready for the new mats it is time to lay out how your mats will look in the foot wells. This is the location the mats will be attached. Trace around the mats using a pencil. This is your reference area to place the mats after the paper is peeled off the back of the mat.

Peel off the paper backing from the mat and line up one end of the mat to your traced out area. (Do Not Try to Install the complete mat in one shot) Slowly work the mat down into your outline.

After the entire mat is installed you must apply even pressure down on top of the mat to insure complete contact to the hull.

Let mats sit for 12 hrs after the install so the glue will fully cure.
Watercraft Superstore's BlackTip Jetsports traction mats have a 1 year manufacturer's warranty against defect in material and workmanship. This warranty does not cover fading, tearing or stains due to user negligence. We do our best to make sure every traction mat set is perfect, but sometimes things happen.

If you should have a problem, please contact Watercraft Superstore @866-957-9277 or sales@watercraftsuperstore.net to identify your issue.
Use only mild dishwashing soap to clean your mats, if you must clean grease from the mats we suggest using Simple Green brand cleaner only to do so.