1.)Remove and separate the whole jet pump from the PWC
2.)For YH Series impeller, remove the trail cone (or cap) from the stator. For all others, hold the front end of the drive shaft with a shaft holder (optional part) on bench vise.
3.)Hold the rear end of the shaft with a bench vise. Remove the impeller with an impeller wrench (optional part). Turning counter clockwise will loosen the impeller.
4.)Visually inspect thread on shaft and impeller for debris or damage. Apply grease or anti-seize on the thread before installation.
5.)Screw the impeller by hand; please be careful of the sharp edge of the impeller. Tighten with the impeller wrench. If the impeller feels too tight or not threaded properly, unscrew the impeller, clean and check the thread.
6.)Assemble the pump and refill O/E pump oil or grease to spec. (for YH series assemble the pump and put it back on the PWC)
*this installation guide is suggested for reference only
*please refer to your original service manual or contact your PWC dealer for detail
*guide provided by Solas
*some wrenches are optional parts and are available for purchase on our website
| Impeller Series |
Wrench |
Holder |
Seal |
YA Super Camber (ABC/IJK Series) |
WR003 |
WR003H |
SL003 |
YB Super Camber (IJK Series)
XProp Series, Concord Series |
WR004 |
WR004H | SLA008 (18mm shaft)
SL008A (15mm shaft) |
YD Super Camber Series (IJK Series) Xprop Series |
WR004 |
WR004H |
SLA008 |
YD Concord Series |
WR007 |
WR007H |
SLA009A |
YF Concord/Xprop Series |
WR007 |
WR007H |
SLA009 |
YG Dynafly Series |
WR007 |
WR007H |
SLA009 |
YS Dynafly Series |
WR014 |
WR014H |
SLA014 |
YS Concord Series |
WR014 |
WR014H |
SLA016 |
YH Concord Series (only for 2005-06 VX110 Sport and VX700 2006) |
WR001 |
 | SLA009 |
